You are here: Troubleshooting > Error Codes > Errors 10-19 > Error 12

Error 12: Timber Width Out of Range

Variable M486

This error is thrown because the width of the timber (stored in variable P430) is not within the allowable range (set between variables P541 and P540).

What to do now

If the timber width is correct, press START to override, otherwise stop the saw by holding down the STOP button.

What to do next

  1. Check that the width of the member on the screen is correct and within the allowable range.
  2. Make sure that the 2* Wide checkbox on the Control Bar is NOT checked. Even if not, check and uncheck and try again.